Carb Rebuild Kit for Standard Keihin 20706-PB

Good deal for the money!

It fit well enough and did repair the problem. However, the float bowl seal didn't fit very well I had to work with it a bit to get it to seal.

As reported by other reviewers the Float bowl orings don’t fit. Had to stretch mine over a spray can of gumout to obtain right diameter,but was thento thin to seal.

I jsut put it in and the rubber rings are the wrong size but I don't have time to send it back so I am going to use a local supplier. I hope they work better for the next guy. I will say the accel pump worked well and the needle seemed to be OK only time will tell

Fixed my bike!!!

As expected

Though I did not purchase this item through Amazon, I did purchase the same product from a local dealership $22+tax. I should have known better. All seals and O-rings were ok, except for the float bowl to carb body O-ring! Like all the other aftermarket carb kits the O-ring is too small and requires some manipulation, stretching, etc. to get the thing to seat. This part of the rebuild should only require a minute or two to complete, not excessive time trying to make the thing fit. O-rings should lay in in the groove without requiring any manipulation...but then again look where it's made!!!

Poor to no fit of gaskets, needle poured fuel. I would not recommend this kit to anyone.