Muzata 20Pack Invisible Cable Railing Hardware Swage Anchor Terminal CR07

these anchors are simple to use...videos are online.

These work great. I used them for 1.5” posts and ground .25” off and they slid in with ease. They’re pricey but worth it when you want a clean look on the side of the post that can be seen.

Cable railing looks great

These were really slick but are overpriced. I used on regular tensioner and one toggle for every line so the at at corners I wasn't trying to run two tensioners through my posts, which means you have to offset the height of your rails so there is room for the tensioners to run crosswise past each other in the post. It made a really clean look overall. Do your toggle ends first: run your cable all the way through the toggle, give it at least two crimps (I did it with a long-handle manual crimp tool just fine), bend the cable out in a T with pliers, insert the toggle into the post, pull the line as tight as you can before you cut the end for the tensioner. I found if I didn't bend the cable into a T out of the toggle I ended up with more slack than expected and I had to redo a few tensioner ends.

I got these not sure if they’d do what I needed for my cable railing and they far exceeded my expectations! They did just the job so I only needed the tightening hardware on one side instead of both. I crimped my cable twice on each piece and it holds so well. I had to drill the hole a bit bigger in the post to accommodate the size of these, but after I did this, they went in the post well and works like a charm. It took some finagling to get the wire to separate from the piece itself sometimes. I bent the wire away from it before putting it in the post, then used a tiny screw driver to finish opening it and pulling the cable to lock it into place. I was very happy with these.