KUAFU Windshield Wiper Cowl Cover Panel Compatible with 2015-2020 Ford F150 Replacement for FL3Z15022A69B Left & Right Front Windshield Wiper Cowl Grille Insert Panel

Installed on 2016 F150. It's a relatively simple install, and you can DIY it after watching a video. The tubes to the wiper fluid spigots are a little short, I wish they were a bit longer, but it fit with some finagling. The spigots are adjustable once you get it installed. Just direct them with some needle nose pliers. Makes the truck look much better, and you don't have to fool with trying to restore the black, which can have fair-to-middlin' results. Over time,it settles in, and the fit gets better.

Great product, perfect fit, 10 minutes to install.

Great fit easy install looks good

Easy install. Looks great. Wiper fluid nozzles included ADJUSTABLE!! Time will tell with regards durability.

I'm glad I bought this, it looks like a factory part and went in fairly easy. I live in the woods in North Florida and it felt like 100 degrees and I had black gnats flying around my face so it made the install a little annoying for me. if it was overcast and in the 70s it would have been a pleasure. Anyway, the old one was shot from the Florida sun and the gasket against the windshield was all cracked up and falling apart. the old one came out OK, connected the included new hose to the new sprayers and the snapped right into place, connected the new hose with the quick connect on the end to the existing hose by the tank. turned the truck on and checked the sprayers, a little low, these can be easily adjusted with a small fine bladed screw driver, pointed them up a little and done. I can highly recommend this aftermarket part. just take your time putting the new one in and make sure the front and rear clips go where they need to go and tuck the rubber in at the ends near the fenders. Add edit: I was going to paint the wiper arms because they looked awful too but after wiping them down good with acetone and alcohol they cleaned up nice.

The rubber and plastic is all fine. The windshield sprayers are horrible. And to make the factory ones fit, I had to cut new holes to fit the factory sprayers added about an hour and a half.

I was a little apprehensive about buying this cowl because I usually buy OEM replacement parts. Needless to say I was very impressed. I work in the plastics business so I know how things are made and how corners can be cut. The ABS was excellent quality and it fit like a glove. No instructions are included but there enough videos online to figure it out. I do recommend trying to save the factory clips on your old one just in case you break the ones that came with it like did, that was my fault as it wasn't aligned right. The windshield washer jets do have to be adjusted, but all you need is a small flat head. It takes a few tries but not long to do. Overall definitely a good option and a lot less than the factory version which is 2-3x this cost.

Fit like a glove. Had my windshield replaced and the OEM cowl did not snap back like was. The rubber was splitting and just looked bad. Took me longer to take off the old one, than putting the new one in. The most IMPORTANT thing is, the sprayers are adjustable. Would buy again.