RC Light Bar 15 LED 2.95 Inch Aluminum RC Lights RC Crawler Accessories for Axial SCX10 Traxxas TRX4 TRX4M Arrma Senton Redcat GEN7 1/10 1/18 Scale Rock Crawler Truck RC Car Roof Light Kit

Installed on a HPI WR8 Flux. My car is technically 1/8 scale but seems just a tad bigger than your average 1/10. All metal and feel very robust. Installed on 3rd channel and when I hit the button on my remote I can cycle through several settings. More than enough wire to run on any body. Highly recommend.

I was so surprised the quality, especially given a lower price. It's got a nice metal case and a built in voltage regulator. It comes with nice mounts that are reversible and the screws and bolts you'll need. It's also so bright. I know you're trying to find pictures to see how bright it is. I don't have a picture but I use this on my fpv RC car. It's so bright. It lights up a dark room in my house and can be seen from so so far away. I wish I had baught this sooner instead of using lights headlights for road bikes. I will definitely be buying this again Only thing I am not sure of/haven't tested is the waterproof rating

Excellent lights have on on most of my RC cars and trucks. Enjoy driving at night 🌉

This bar works perfect. The only thing I did not like was that it was very bright. If the car is coming at you and the light is facing up you will not be able to look at it directly.

Honestly, pretty good light for the price, quality and bright as well. The only thing I encountered is when I first plugged it in with the switch, it wasn’t bright at all, but when plugged straight into the receiver box, it was more than bright enough, obviously by doing that every time you turn on the car, the light will always be on, but I don’t mind that at all. Besides that it was pretty easy to install you just have to be comfortable with probably making some holes in your cars body

These are the brightest lights I have ever purchased for my RC vehicles. I use them as side light bars on my SCX6, and they blow my main 56 LED light bar out of the water, which makes me disappointed in my main light bar. Now I have to replace it. I wouldn't care if it was a slight difference, but it is too noticeable. I hate you for being so good.

Nice and bright, really solid and sturdy, survived a nasty crash and I think it kinda aided actually! If I do another build, Ill be buying again!

Update 2: 6v is perfect and does not heat up nearly as much. Update: Be very careful where you mount these. They got very hot even to the touch over time. It takes a minimum of 10 minutes but does continue to get hotter. Its to be expected with the output but it will soften PLA 3D printed parts at 7.4V. Its rated for that and higher but the manual does says optimal is 6.0V. I was worried about the wires getting warm but after 20 minutes, it was only the metal on the lightbar itself. Put two of the smaller light bars on top of my Cross NT6 and it's incredible. Extremely Bright. Even with the vertical mounts in the roof rack, it still lights up everything in front of it. I did not use the included controller, it was fine but preferred a simple on and off. The included controller does on, breathing and strobe. Mounts are metal, rear fins are metal and it even has a see thru piece in front of the LEDs. I assume they will draw some voltage but being on a crawler and LED I am not too worried. Hopefully I can update after a few runs. Very happy with these. Looking forward to adding more to my other rigs.