A-Pillar Molding Trim Kit Outer and Inner Trim Set Replacement for 2011-2019 Ford Explorer 4 Door Utility (Left & Right) Replaces 926-451 926-450

When the trim flew off my 2017 Explorer on the highway and the dealer gave me the run-a-round about honoring the ford recall to replace, I found this product on Amazon. Excellent product! Solid (hefty) construction, well built. Perfect Fit on my 2017 Explorer. Top quality finish and ease of installation with advise strip for good bonding. They even included extra clips. I highly recommend!!

Change secondary piece as well! does not work with factory part that's bolted into car. Product works great once both pieces are replaced. make sure tabs are lined up properly or it will break

I ordered left and right Inner and Outer. Inner went in very easily. Only complaint is the left outer piece broke during installation on one side. When adjusting the fit to ensure all snaps were lined up, the piece broke in half.

Installation and fit was perfect. No issues at all. Removed the cracked originals, cleaned the area really good and installed the new ones. Installation was easy. No instructions at all. I had viewed a few youtube videos beforehand to familiarize myself with the Installation. FitSo 5 out 5. Now, I haven't driven it yet. So, if in a short time it flies off or something else crazy goes wrong, I'll be sure to update this.

Did not line up properly, when I tried to take back off and redo it snapped in half so very cheap plastic and not aligned properly. Other side the top tab came unglue because I forced it into shape. Not worth the money

Perfect replacement for my 2016 Explorer. Not sure why people are complaining about fit and it breaking. Here are some suggestions for installation… - bite the bullet and replace plastic base which screws onto A pillar - clean everything well - be sure to remove the original top click which tends to stay in the frame (if you replace the base) - mark ALL of the clip points with blue tape on the exterior of the glossy finished trim piece. This will help you remember where to GENTLY push onto the base. - DO NOT use the provided adhesive strip. Ford does not provide one. I think this after market one had it installed to ensure it would never come off. The problem is that if you are not perfect on alignment on the first attempt, you run the risk of breaking it trying to pull it off to move it. There are 8 holding clips. You do not need the adhesive.

Fit perfectly. Looks like new car!

Very flimsy but it works. You must dry fit alignment before you commit to clicking it in. I haven't experienced cracking or them flying off after about 6 months of usage.