WinfloWinflo 2W 12V Energy Saver LED Soft White (Yellow Tone) Ultra-Bright Replacement Light Bulbs Range Hoods ONLY (Set of 2pcs)

Clicked in, and they work perfectly. The light feels like a very warm white to me.

Original lights were very weak and my wife could not see when cooking. I replaced them with these and it was a very significant improvement. Replacement took about 10 minutes.

Light very dim didn’t sit correctly in housing none the less they worked

Received one that didn't work. Very yellow and not desirable at all. Dimensions claimed by seller are incorrect. The dia is slightly larger. Very cheap product and seller is not helpful. Charged me for retiring a defective part. Beware of this seller!!

I used this to replace the blue-tinted downlights that came in my zline range hood. It took a little fiddling – including splicing the zline wire connector onto the ends, and shimming the clips to stay under tension –  but in the end, the piece does fit, the color temperature is what I want (warm), so this worked for me, even though it's not the intended usage.

I bought these as a substitute for my Kaff chimney lamps, which are no longer available. It's a tad smaller(about 1/8" on either side) than my OE lamp, but I glued it into place(which could be a small headache to remove if I ever have to replace these!). Of course, the snap-together connector is different as well, but that wasn't an issue as I connected the wires directly(red to red and blue to black). I was pleasantly surprised at the amount of light output, and the bright white(cool white) is a lot better for illumination than the soft white I previously had. If these last at least two years, I would definitely buy again. All in all, a great product.

We had to retrofit the ending to make it work on our range hood, but the lights fit and work great.

Bought these because another review said they'll fit AKDY hoods. They do not. These are smaller then the L09 LEDs on the akdy hood.But you can take them apart. Pretty the metal tabs off the winflow surround, pop the lens out, cut of the connector, and pull the led out. The akdy bulb comes apart with 4 screws. I used some 100grit paper to send the winflow led board to round it until it fit the akdy reflector, then cut the gap in the akdy housing to fit the thicker gauge winflow wires, soldered the akdy connector to the winflow led wires and reassembled it. Easy peasy.Looks much better than the cool white that came with the akdy hood. All the pics show the akdy bulb on the left, winflow on the right.